-
Heat Cure. Single Component semi-flexible epoxy potting and encapsulating system. Product is suitable for potting ferrites and pressure sensitive components in electrical and electronic applications. Low viscosity. The product has excellent stability and good adhesion to a wide range of substrates. This product meets UL94-HB flammability requirements. CLS 9616
-
UL 94-V0 certified fast setting, potting / casting PU for transformers, coils, and electronic components. A two component, low viscosity, polyurethane casting system, specifically designed for casting transformers, coils and electronic components. Product has excellent thermal shock resistance. XP 61862 / CLI 4161
-
Density = 0.80. A low viscosity, low density, user-friendly, room temperature cure, MDI based polyurethane system. The product cures to a hardness of 60 shore A, and has a cured density of 0.80 gms/cm3. XPD 1401 / CLI 4182
-
Excellent fuel resistance. Suitable for automotive fuel sensors. A two component, chemical resistant epoxy casting system. The cured product has improved thermal conductivity for applications where heat dissipation from thermally sensitive devices is required. Cured product is resistant to Ethanol, Gasoline, and Diesel, when exposed to these chemicals at ambient or elevated temperatures. XR 11483 / CLH 6260
-
1:1 machine dispense adhesive. Adhesive for bonding synthetic aggregates to metal. A medium viscosity, room temperature curing, two component epoxy adhesive. Product was developed with improved thin film set time when bonding metal substrates. XR 52092 / XH 62093
-
High temperature clear epoxy. An unfilled, heat resistant, clear laminating system. Products low viscosity gives the system excellent wet-out properties to fibreglass and other reinforcing fibres. The material exhibits high physical strengths and modulus with moderate post cure temperatures. XRD 1014 / XHD 1015
-
1:1 Mix Ratio, 130°C Operating, General Purpose, Low cost. A two component, room temperature cure semi-flexible, flame retardant, epoxy system. The system was developed for potting/casting of electrical and electronic components. Its use of non-abrasive fillers and convenient 1 to 1 ratio by volume, make it ideal for use in machine dispensing equipment. This product meets UL94-V0 in house flammability testing. XRD 1018 / XHD 1019